AD9850 Set Frequency and Phase
Set the frequency and phase of the AD9850 output signal.
Inputs
CS Channel
Specifies the LINX device digital output channel that is connected to the AD9850 chip select pin.
SPI Channel (0)
Specifies the LINX device SPI channel that the AD9850 is connected to.
LINX Resource
Contains LINX connection resources.
Frequency
Specifies the desired output frequency in Hz.
Phase Offset (5-bit)
Specifies the desired output phase offset in degrees.
Error In
Describes error conditions that occur before this node runs. This input provides standard error in functionality.
Ref Clock Freq (125MHz)
Specifies the AD9850 reference clock frequency. This value is used to calculate the value to write to the AD980 to achieve the desired output frequency.
Outputs
LINX Resource
Contains LINX connection resources.
Error Out
Contains error information. This output provides standard error out functionality.
