This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
~ ~ NOTOC~ ~
Set the frequency and phase of the AD9850 output signal.
CS Channel Specifies the LINX device digital output channel that is connected to the AD9850 chip select pin.
SPI Channel (0) Specifies the LINX device SPI channel that the AD9850 is connected to.
LINX Resource Contains LINX connection resources.
Frequency Specifies the desired output frequency in Hz.
Phase Offset (5-bit) Specifies the desired output phase offset in degrees.
Error In Describes error conditions that occur before this node runs. This input provides standard error in functionality.
Ref Clock Freq (125MHz) Specifies the AD9850 reference clock frequency. This value is used to calculate the value to write to the AD980 to achieve the desired output frequency.
Error Out Contains error information. This output provides standard error out functionality.
AD9850 Open LINX VI Reference