Table of Contents
Getting Started With the AR Drone
This tutorial describes how to get started with the MakerHub Interface for the AR Drone and covers software setup through running a the first example application.
Prerequisites
Hardware
Software
Procedure
Setup Hardware and Software
- Install the MakerHub Interface for the AR Drone.
- Power on the AR Drone.
Run an AR Drone Example
- In LabVIEW click HelpĀ»Find Examples
- Click the Search tab
- Search for 'AR Drone'
- Open the AR Drone Read Navigation Data example from the LabVIEW Example Finder.
- Follow the instructions on the VI front panel.
Help / Support
If you have any questions about getting started with the MakerHub Interface for AR Drone please search the MakerHub forums and create a new thread if you cannot find the answer to your question.