This tutorial describes how to get started with the MakerHub Interface for Kinect One and covers software setup through running a first example. New users are encouraged to start here.

• LabVIEW Basics
• Note: the Microsoft Kinect One Requires Windows 8 x64 or later. The MakerHub Interface for Kinect One only works with the 32-bit version of LabVIEW running on Windows 8 x64 or later.

• LabVIEW
• Microsoft Kinect One SDK

• Install the Kinect SDK 2.0
  
  
• Install the MakerHub Interface for Kinect One
  
  
• Connect the Kinect sensor to a USB 3.0 port.
  • Note: Make sure you meet the Hardware requirements for the Kinect One sensor.
    
    

• Launch LabVIEW
  
  
• Click Help»Find Examples
  
  
• Click the Search tab
  
  
• Search for 'Kinect'
  
  
• Open an example and follow the instructions on the front panel.
  
  

If you have any questions about getting started with the MakerHub Interface for Kinect One please search the MakerHub forums and create a new thread if you cannot find the answer to your question.