Getting Started With the Xbox One Controller

This tutorial describes how to get started with the MakerHub Interface for the Xbox One Controller and covers software setup through running the first example application.

Prerequisites

Hardware

Software

Procedure


Hardware and Software Setup
  • Install the MakerHub Interface for the Xbox One Controller Controller

  • Connect your controller via USB and make sure the drivers are installed correctly.

Run an Xbox One Controller Example
  • In LabVIEW click HelpĀ»Find Examples

  • Click the Search tab

  • Search for 'Xbox'

  • Open the Xbox One Controller - Polling Read example from the LabVIEW Example Finder.

  • Follow the instructions on the VI front panel.

Help / Support

If you have any questions about getting started with the MakerHub Interface for Xbox One Controller please search the MakerHub forums and create a new thread if you cannot find the answer to your question.