Page 1 of 1

LINX Local I/O on Mac

PostPosted: Wed Mar 06, 2019 4:25 am
by kreiseda
Hi Makers,

a colleague wants to use the LINX module in combination with an Raspberry. he wants to use it in the Local I/O mode like described here.
https://www.labviewmakerhub.com/doku.php?id=learn:libraries:linx:misc:linx-internals

So at the end the target should run standalone. He is developing with an LabVIEW Full Development System on MacOS.
Question is, is it neccessary to have the Application Builder to use the Local I/O mode of LINX ?

Thanks
Andreas

Re: LINX Local I/O on Mac

PostPosted: Wed Mar 06, 2019 10:09 pm
by nathanb
IIRC, it requires Application Builder and the LabVIEW Real-time module and I think it still only supported in LabVIEW 2014. I'm not sure if these are available for Mac.