Page 1 of 1

Revert Timing Out?

PostPosted: Wed May 28, 2014 12:46 pm
by mark
Uploaded a small vi to take it back to LV2011. Got a pop-up saying, "The worker was unable to convert the files before the timeout. Please try again. If this problem persists please post on the LabVIEW Hacker forums."

I'm using Chrome 35.0.1916.114 m on Windows 7 Enterprise 64bit. I've tried multiple proxy configurations, and one through an unproxied 4G connection.

It's a pretty simple vi, so I'll rewrite it, but it's using LINX v1.1a. Would LINX v1.1a prevent Revert from working?

Mark

Re: Revert Timing Out?

PostPosted: Thu May 29, 2014 11:40 am
by samkristoff
Hey Mark,

I don't think I have LINX installed on the Revert worker, so it's probably stuck searching for the LINX VIs. I'll check when I get a chance. If you use revert with LINX VIs it will always return the LINX VIs of the version installed on the worker (this will be the current released version) so just be careful if you're using an alpha or beta build.

Re: Revert Timing Out?

PostPosted: Fri May 30, 2014 2:38 pm
by mark
That's kinda what I figured. It's just that open-close port vi, so LINX v1.1 is basically all that's in it other than a couple controls. So not a problem to recreate in LV2011.

Re: Revert Timing Out?

PostPosted: Mon Aug 18, 2014 8:13 pm
by prvtmg
Even I encounter the same issue when i try to convert the file