Page 1 of 1

AD2 & ACL2 and WaveForms in LabVIEW

PostPosted: Wed Jun 22, 2016 5:38 pm
by ellaceline
I'm working on a project with a goal of using the Analog Discovery 2 to read accelerometer data from the Pmod ACL2. I have the WaveForms VI package for LabVIEW installed and up and running. I have the ACL2 CS, CLK, and Data line hooked into the AD2 digital I/O 6, 1 and 0, respectively.

I have the ACL2 wired into the chipKIT WF32 and it's working perfectly in LabVIEW. It's all on a breadboard so I'm running the data lines, etc from the ACL2 to both the WF32 and the AD2. I ran the AD2 through the logic analyzer on the actual WaveForms 2015 program to makes sure it was actually receiving data and everything looks good on that end.

I want my LabVIEW graph to read the accelerometer data from the Analog Discovery just like it reads it from the WF32.

Right now I get a graph that shows a logic high on channel 6, but it hangs there and doesn't continuously read.

I'm using LabVIEW 2013 on Windows 8.

A picture of my code is attached. Let me know if there's anyway to accomplish what I'm thinking.

Thanks,

Ella