Page 2 of 2

Re: Neato Lidar project

PostPosted: Tue Jun 23, 2015 10:19 am
by bcolon1665
good morning

I am currently working with the neato lidar and i downloaded the drivers and Vi libraries from Labview Hacker. Everything installed properly but when i run the Lidar example my lidar stops rotating. Afyer that when i hit stop it continues working again. I bought the from Robo Peak. it has its own board and FTDI. They have an app that does the same thing and it runs perfectly but when i use it on labview it stops working. what should i do?

Re: Neato Lidar project

PostPosted: Tue Jun 23, 2015 9:20 pm
by samkristoff
Do you get any data in LabVIEW?

Re: Neato Lidar project

PostPosted: Tue Jul 21, 2015 10:29 pm
by m3765
nothing wrong with the Neato code its smooth as butter.
plz have a look at the hardware you are using.
it should work without any modification.

Re: Neato Lidar project

PostPosted: Tue Jul 21, 2015 10:34 pm
by m3765
you are right sam neato code works with arduino serial lines .i can even get visualization.
i have started further into navigation programming

Thank you

Re: Neato Lidar project

PostPosted: Thu Oct 13, 2016 10:45 am
by airthang
When I click on the link to the Neato Project Page, the link does not work anymore. Could anyone please point me to the right position or share the file with me?

Regards,
TN