chipKit uC32 with labview

[QMESAR]

Hi All.

I have a uC32 chipKit board and I would like to start to learn Labview and LINX however please guide me with the following question/confusion

I have used this board with MPLABx and the original Firmware/ bootloader which the board was suppliedd with 2 years ago is not installed any longer,
I have the Bootloader Firmware which I can program the board with however my question is is there another Firmware /hex file to be programmed to the device
to allow connection to LABVIEW?

Please any advise information will be highly appreciated
Regards
QMESAR

[QMESAR]

Hi All.
I found the solution thank you any case for approving the post although it took one month to be approved.

Regards