Blinking LEd project the LED Always ON

by **mustafasei** » Sat May 12, 2018 12:07 pm

Hi
I have follow all the instructions in the this video 05 | Blink! and the previous videos for RPi3 installation and every thing was fine but when I hit the run button the LED NOT blinking and always ON.
I changed the GPIO from 7 to 8 and I got error message that GPIO in RPI2 not supported and same if I select other GPIOs
also why I see in the project RPI2 and NOT RPI3

any advice please

by **mustafasei** » Sun May 13, 2018 5:16 am

Hi
I repeat the RPI3 setup again and I found the LED became ON after installing the labview to the RPI as attached picture
please help if you have any solution

by **mustafasei** » Mon May 14, 2018 9:18 am

NO Answer ??!!!

by **mustafasei** » Sat May 19, 2018 4:33 pm

Just like I'm alone in this forums
Wgy nobody can answer me even the admin

Blinking LEd project the LED Always ON

Blinking LEd project the LED Always ON

Re: Blinking LEd project the LED Always ON

Re: Blinking LEd project the LED Always ON

Re: Blinking LEd project the LED Always ON

Who is online