This is an old revision of the document!
Table of Contents
Getting Started with the MakerHub Interface for Kinect One
This tutorial describes how to get started with the MakerHub Interface for Kinect One and covers software setup through running a first example. New users are encouraged to start here.
Prerequisites
- Note: the Microsoft Kinect One Requires Windows 8 x64 or later. The MakerHub Interface for Kinect One only works with the 32-bit version of LabVIEW running on Windows 8 x64 or later.
Hardware
Software
Procedure
- Install the MakerHub Interface for Kinect One
- Connect the Kinect sensor to a USB 3.0 port.
Run a Kinect example
- Launch LabVIEW
- Click HelpĀ»Find Examples
- Click the Search tab
- Search for 'Kinect'
- Open an example and follow the instructions on the front panel.
Help / Support
If you have any questions about getting started with the MakerHub Interface for Kinect One please search the MakerHub forums and create a new thread if you cannot find the answer to your question.